Milos3 6 Report post Posted May 24, 2011 Ciao a tutti, volevo chiedere un consiglio: il mio movimento centrale, probabilmente vecchio e logorato, ha uno spostamento che non dovrebbe avere in verticale. Mi spiego meglio: la regolazione della ghiera è giusta perchè orizzontalmente sta fermo, ma ha un leggero movimento in alto e in basso. Cosa mi conviene fare? Lo devo cambiare per forza o lo tengo così? Share this post Link to post Share on other sites
Tomaradze 748 Report post Posted May 24, 2011 Stringi ancora le coppe del movimento centrale. Il fatto che non si muova a destra e sinistra non è indice che sia stato tirato abbastanza. Le sfere come sono messe? E la sede delle sfere? Share this post Link to post Share on other sites
Milos3 6 Report post Posted May 24, 2011 eh le sfere sono libere perchè la sede era tutta consumata e rischiava di danneggiare ulteriormente il movimento centrale che è già molto logorato. Tu consigli di stringere ancora? Share this post Link to post Share on other sites
Tomaradze 748 Report post Posted May 24, 2011 Le sfere libere vanno bene, ma se togli le gabbie devi aggiungere delle sfere perché la gabbia le distanzia un po'. Altrimenti se la sede è molto rovinata, con buchi e altro, allora è meglio cambiarlo. Share this post Link to post Share on other sites
Milos3 6 Report post Posted May 24, 2011 Ma da quello che mi ricordo ho messo il numero giusto di sfere... Probabilmente sarà molto rovinato l'asse del movimento, vedrò di cambiarlo a sto punto! Share this post Link to post Share on other sites
Tomaradze 748 Report post Posted May 24, 2011 E ricorda di prenderne uno che abbia la lunghezza del perno che coincida con quello che la tua guarnitura richiede. Share this post Link to post Share on other sites
Marciuz 318 Report post Posted May 24, 2011 Ciao, nel mercatino ne trovi qualcuno...(passo inglese lunghezza 115 e uno da 107) a un prezzo onesto! ad esempio qui Ma di fisso hai un filetto italiano... Share this post Link to post Share on other sites